In most models the sensor is white, but can also be gray or black. Mechanical sensors are also located in the very center of the paper entry throat and look like a small plastic divider in the middle of the cutting blades. Some of Fellowes smaller home shredders offer a mechanical sensor rather than the electronic version. If you do not have electronic sensors, see below for additional instructions. Also if there is any visible paper debris in this area, remove with cotton swab or needle nosed pliers.Īlmost all of the time, this procedure will solve the problem, and may be repeated as part of routine maintenance as needed. You may need to clean it a couple of times. Once you locate the sensors, use a cotton swab dampened with rubbing alcohol to wipe away any residue or dust. You will need to look past this lever in order to locate the auto sensors. PS79Ci, 79Ci, SB89Ci, SB99Ci, etc.) there is a paper gauge lever in the middle of the entry. Please note that if you have an Intellishred shredder (i.e. If your model has a safety flap over the cutters, you may need to lift this to get access. To locate the sensors, unplug shredder and look in the paper entry throat and in the very center there will be two small sensors that look like small glass beads or marbles. The good news is that it is as simple as wiping off the sensors to clear away anything that may interfere. This is a little bit more of a problem on cross cut shredders since the oil can very easily cloud the sensors. If paper dust, debris or oil has covered the sensors it can break the signals (indicating to the shredder that paper is being entered) and can cause the shredder to run continuously. These are designed to work by shooting a signal to each other when the signal is broken (by paper entering the throat) the shredder turns on, and when the paper passes through completely, the sensors are able to recognize the signals and the shredder turns off. In most cases, if a shredder is running continuously, this does not indicate that anything is broken.Ī majority of Fellowes shredders have 2 small electronic sensors in the throat of the paper entry slot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |